Trelleborg SCN 1000, Руководство по обращению, хранению, установке и техническому обслуживанию, Страница: 15 / 28

14
installation
2.1 Fender To STeel PAnel
This section showcases the various steps involved for assembling the fender/fenders to the PMf unit.
MATeriAlS / conSuMABleS required inForMATion
Timber / rubber blocks
The fender must be placed on timber / rubber blocks
to avoid any damage to the rubber body.
recoMMended equiPMenT inForMATion
general PPe As per site / plant requirements
equiPMenT required inForMATion
Fasteners supplied by Trelleborg
Spanner suitable to the supplied bolt size
2.1.1 Scn fenders to Steel Panel
Assembling Scn fenders
❙
fix the ”first” fender on the spool.
❙
Align the sandwich plate as shown on the image.
❙
lower the ”second” fender on the sandwich plate
such that the bolt holes are aligned.
❙
Insert and torque the bolts.
recommendations
❙
After inserting the bolts, only turn enough to
ensure the threads are engaged and in line. once
all bolts are loosely inserted and the holes are
aligned, tightening may be commenced. firmly
fasten all bolts and then torque down, ensuring
that adjacent bolts are not tightened in sequence.
❙
for fastening to rubber, torque values from
Appendix A should be used.
❙
standard bolt torque values should be used when
fastening to steel.
❙
refer to MN-I&M-rub-scN&scK-v1.0- EN, 2017
for fender lifting methods.
caution
The “first” and “second” fenders must be identified
based on their grades prior to the commencement
of installation. refer to the general Arrangement
drawing.
Figure 6
: Assembling “back-to-back” scN fenders
sandwich
plate