A
U
n
i
t
o
f
I
D
E
X
C
o
r
p
o
r
a
t
i
o
n
PAGE 10
2472 DI HEATER OPERATION / MAINTENANCE MANUAL
3
INSTALLATION
3.1 UNPACKING
Remove heater system from crate and inspect heater cabinet for any
signs of damage (dented panels, paint scratches, etc.). Shock indicators
inside the heater cabinet should be checked for rough handling during
shipment. Any damage to the system should be reported to the carrier
immediately.
!
CAUTION:
Heavy Object. When lifting or moving the system, follow
safe heavy object handling methods to prevent injury.
Be careful when using a dolly or forklift to not damage the drain fitting
located under the heater cabinet.
3.2 LOCATION
Locate the heater near the point-of-use to reduce plumbing heat loss.
Access to the front and rear of the system will be necessary for
maintenance and hook-up. For heater replacement, access to the top
and sides of the enclosure are required. This access can be achieved by
disconnecting the fluid and power hookups (see Section 2.6) and moving
the heater to a serviceable area.
NOTE:
The DI water heater must be allowed to stabilize at installation
location at ambient temperature and humidity for 24 hours before
operation. Refer to Section 3.3 for system requirements.
