Gas/Pellet Remote Thermostat
SKU 99300646
Page 5 of 8
11/11/09 - 17601251
© Travis Industries, Inc.
Remote Receiver Calibration
1
Remove the cover from the back of the transmitter. Insert three "AAA" batteries into the transmitter
as shown. Slide the code switches to a random position on the transmitter.
ON DIP
1 2 3 4
Transmitter
Dip Switches
Transmitter
AAA Battery
AAA Battery
AAA Battery
ON DIP
1 2 3 4
C-P
Slide the
access
cover off.
Set these dip switches to a
random position.
2
Plug in the receiver. Position the transmitter within 1 foot of the receiver. The LED indicator panel on
the transmitter should be flashing (if not, remove and replace the batteries). Press down any button
on the transmitter until the receiver "beeps". This indicates the transmitter and receiver are calibrated
on the same radio frequency (if it does not, remove batteries, replace, and repeat this process). Test
operation of the remote control.
Receiver
ROOM TEMP
°F
°F
SET TEMP
PM
Set
Time
Cancel
:
MA
N
U A
L
O
N
/O
FF
A
T O
U
N/
F
O
O
F
Flame
Height
Fan
Speed
"Beep"
Setting the Time
ON
ROOM TEMP
°F
°F
SET TEMP
TIMER
MIN
TIMER
CLOCK
“UP” and “Down” Arrows
1. Press and hold the “CLOCK” button for 2
seconds.
2. The hour display will flash. Use the “Up”
and “Down” arrow buttons to set the hour.
3. Press the “CLOCK” button again.
4. The minute display will flash. Use the “Up”
and “Down” arrow buttons to set the
minute.
5. Press the “CLOCK” button again.
6. The “F” or “C” display will flash. Use the
“Up” and “Down” arrow buttons to select
Fahrenheit or Celsius.
7. Press the “CLOCK” button again.
Programming is complete.
Fahrenheit or
Celcius Display
“CLOCK” Button
Hour and Minute Display
MANUAL
ON/
OFF
ON/
OFF
AU
TO
