20 Installation
(for qualified installers only)
Travis Industries
4090709
100-01222_000
Optional Wall Switch or Thermostat Installation
Do not connect 110-240 VAC to the gas control valve or wiring system of this fireplace. The switch
must be installed by a qualified installer.
This fireplace includes an optional wall switch (with wire)
to operate the fireplace burner without accessing the
internal on/off switch. A thermostat may be used instead.
Route the wire from inside the fireplace, through the
grommet on either side of the fireplace near the gas inlet
(see at right) to the switch. The wall switch (or thermostat)
may bypass the fireplace on/off switch or be installed in
parallel or series configuration (see below).
Caution
:
Label all wires prior to disconnection when
servicing controls. Wiring errors can cause
improper and dangerous operation.
Note
:
When using a GreenSmart™ remote, use the
receiver for on/off operation (do not use a wall
switch or thermostat).
Warning
: Make sure all wiring is secure and does not
contact hot or moving components.
OPTIONAL WALL SWITCH
(included with fireplace)
Place "WARNING"
label on switch cover.
Parallel Connection
Series Connection
On / Off Switch
ON
On / Off Switch
OFF
On / Off Switch
ON
On / Off Switch
OFF
Thermostat / External
Switch
ON
Heater is
ON
Heater
is
ON
Thermostat /
External Switch
ON
Heater is
ON
Heater
is
OFF
Thermostat / External
Switch
OFF
Heater is
ON
Heater
is
OFF
Thermostat /
External Switch
OFF
Heater is
OFF
Heater
is
OFF
To wire the heater in parallel, follow the directions below:
To wire the heater in series, follow the directions below:
Thermostat
(or External Switch) Wires
a
b
c
On / Off Switch
a
On / Off Switch
c
b
Thermostat
(or External Switch) Wires
