Program 25 : Reset Data to System Default
25 - Reset Data
0 - 9 Default
General:
This program resets all data to System Default. All new systems must be reset to default before any programming in
case corruption has been caused during handling or shipping. It will also be necessary to reset to default after a
software upgrade is installed. When using item 3 or 4 these must be done AFTER the system reset is performed.
Description:
1 = System data will be reset to system default except System Speed Dial Programming.
2 = The system data will be totally reset to system default.
WARNING
: All user-defined data will be lost.
3 = For all Stations
44-st-02=1
(Hold Feature restricted)
44-st-03=1
(Call Split Feature restricted)
This feature is for Hotel/Motel operation. After setting this Mode, it is necessary to reprogram the
Console and any Administration phones in Mode 44-st-02 to allow them to place calls on hold.
4 = For all Stations
40-st-01=0
(Barge In not allowed)
40-st-02=0
(Monitor not allowed)
It is strongly recommended that this parameter is used on ALL systems to prevent accidental
Barge In operations being misinterpreted as cross talk. In some software versions these settings are 0 in default. All
other system programming information remains unchanged when using 3 or 4.
6 = Voice Prompt Copy – On-Board AA to VMU
This parameter transfers AA Greeting messages from the MBU AA Flash to the VMU Flash.
This feature takes several minutes to achieve. Do Not interrupt. When the transfer is in operation the LED on the VMU
and the LED on the MBU adjacent will fast flash in unison until the transfer is complete.
7 = Voice Prompt Copy – VMU to On-Board AA
This parameter transfers AA Greeting messages from the VMU Flash to the MBU Flash.
This feature takes several minutes to achieve. Do Not interrupt. When the transfer is in operation the LED on the VMU
and the LED on the MBU adjacent will fast flash in unison until the transfer is complete.
8 = Reset all Voice mail Box message
This parameter will clear voice message that stored in all voice mail box
9 = Reset DSP
Activate the DSP circuit in the motherboard of G1E+ and keep the rest of system still working normally.
It is used when DSP stop working and user doesn’t wish to reset the entire system.
# = update the loader, LCD displays "Update Loader SW", Press [1] to update loader.
Содержание G1E Plus
