13
12
MEASUREMENT
BEFORE YOU START
Tie the cuff
1.
4.
Hold your arm with your palm facing up and
tie the cuff
on your upper arm, then position the tube off-center
toward the inner side of arm in line with the little finger.
Or position the artery mark over the main artery (on
the inside of your arm). Note: Locate the main artery
by pressing with 2 fingers approximately 2 cm
above the bend of your elbow on the inside
of your left arm. Identify where the pulse can be
felt the strongest. This is your main artery.
The cuff should be snug but not too tight. You
should be able to insert one finger between the cuff
and your arm.
Remove all jewelry, such as watches and
bracelets from your left arm.
Note: If your doctor has diagnosed you with
poor circulation in your left arm, use your right arm.
Roll or push up your sleeve to expose the skin.
Make sure your sleeve is not too tight.
2.
3.
Sit comfortably with your tested arm resting on a flat surface. Place
your elbow on a table so that the cuff is at the same level as your
heart. Turn your palm upwards. Sit upright in a chair, and take 5-6
deep breaths.
Rest for 5 minutes before first measuring.
Wait at least 3 minutes between measurements. This allows your
blood circulation to recover.
The patient must relax as much as possible and do not
move and talk during the measurement procedure.
For a meaningful comparison, try to measure
under similar conditions. For example, take daily
measurements at approximately the same time,
on the same arm, or as directed by a physician.
5.
6.
Take the measurement in a silent room.
The cuff should maintain at the same level as the right
atrium of the heart.
Please sit comfortably. Do not cross your legs
and keep your feet flat on the ground.
Keep your back against the backrest of the chair.
Helpful tips for Patients, especially for Patients with Hypertension:
2~3cm
Pair up with Your Device
(1)Turn on Bluetooth and the app. Make sure both are ON
when pair-up is proceeding.
(2)When the monitor is OFF, press and hold the MEM
button to start pair-up. The below picture will be shown
on the LCD alternatively,indicating pair-up is proceeding.
If SUCCEED
,
the below picture
will be shown on the LCD.
If FAIL
,
the below picture
will be shown on the LCD.
(4)The monitor will shut off after Pair-up process is
complete.
(3)Then connect with your smartphone on the app to continute the pair-up.
