Transpak GENESIS HORI TP-502MH, Руководство по эксплуатации, безопасности и запасным частям, Страница: 27 / 117

-A22-
b. TP-502MHB
1. When operate the machine with battery power, Check the plug connection inside of
Battery Case should be
○ B
and
○
I (Power from battery to Inverter).
2. Turn main switch QS1 to ON. The heating element will reach the working
temperature in approximately 40 second. Green Lamp flash when heating element
under heating, Green lamp will keep on when temperature reach.
3. Press reset button to start up the machine.
4. Move the machine to close to the package, the strapping head should be close to the
corner of the package (or will cause not easy to threading the strap into the strap
inlet), pull strap around the package and insert the leading edge of the strap into the
strap inlet to activate the strapping cycle. Then the strapping cycle is completed.
5. Move the strapping head up and down to the next strapping position and repeat the
strapping process until the last strapping is finished.
6. Move the machine away from the package.
7. After operation, please turn off switch QS1 before Unplug the wire connection
○
B
&
○
I .
c. The meaning of Lamp blinking
：
1. Normal Situation:
Switch on the
power of the
machine Under
heating Strapping
cycle start
(SQ1 ON) Machine
ready to
use Sleep mode
(10 minute
without using) Sleep mode
(Deep) (1hour
without using)
Amber
Lamp Both lamp
are blinking 3
times at same
time OFF ON OFF OFF OFF
Green
Lamp blinking Continue
ON
Continue
ON Blinking (two
quick and one
slow blinking) Blinking (One
quick and one
slow blinking)
If the machine goes into sleep mode, you have to push reset button to start up the
machine if you would likes to use the machine again.