BATTERY INSTALLATION(REMOTE CONTROL UNIT)
THE CAUSES OF INTERFERENCE
1.
Remove the battery cover
2.
Insert the 2 AAA 1.5V batteries making sure the poor -)of the batteries matches the polarity
marks inside the unit
.
3.
Replace the battery cover.
Replace with new batteries when the TV set begins to show the following symptoms:operation is unsteady
or erratic.Sometimes the TV set does not function with Remote control unit.
Remark:
1) Alkaline batteries recommended
2) Remove batteries when they are exhausted or if the remote control is not to be used for a long time.
Incorporated in your TV receiver are the most
up-to-date devices to eliminate interference.
Local radiation however, can create
disturbances which visibly affect your picture.
Proper installation, a good aerial are your
best safe-guards against these disturbances.
INTERFERENCE
Moving ripples across the screen are caused by
nearby transmitting or receiving-short-wave
radio equipment..
DIATHERMY
Herringbone pattern and partial picture loss can result
from the operation of diathermy equipment From a
nearby doctors surgery or hospital.
SNOW
Weak TV signals from long distant stations give
the effect of falling snow. An antenna adjustment
or antenna amplifier may be needed.
GHOST
Multiple image caused by TV signals reflected
back from surrounding buildings, hills, aircraft, etc.
are minimized by correct aerial positioning.
CAR IGNITION
Nearby cars and electrical motors can cause small
streaks across the picture or make the picture roll.
-15-
