Transition Networks
SPOEB10xx-105 User Guide
33618 Rev. C
https://www.transition.com/
Page
10
of
16
Cable Specifications
The cable’s physical characteristics must meet or exceed IEEE 802.3
™
specifications.
Copper Cable
Category 5: (Minimum Requirement)
Gauge: 24 to 22 AWG
Attenuation: 22.0 dB /100m @ 100 MHz
• Straight-through OR crossover twisted-pair cable may be used.
• Shielded twisted-pair (STP) OR unshielded Twisted-pair (UTP) may be used.
• Pins 1&2 and 3&6 are the two active pairs in an Ethernet network.
• RJ-45 Pin-out: Pin 1 = TD+, Pin 2 = TD-, Pin 3 = RD+, Pin 6 = RD-.
• Use only dedicated wire pairs for the active pins:
(e.g.,
blue/white & white/blue, orange/white & white/orange
, etc.)
• Do not use flat or silver satin wire.
Fiber Cable
The fiber optic transmitters on this device meet Class I Laser safety requirements per IEC-825/CDRH standards
and comply with 21 CFR1040.10 and 21CFR1040.11.
Fiber Specifications
SPOEB1011-105 (ST)
1x9, 850nm, ST, MM, 3.3V
Multimode, Dual fiber, Distance = 2km,
Wavelength = 1310 nm
Data rate = 100Mbps
Max Spectral Width = 400.0nm FWHM
Min Tx Power=-19.0 dBm
Max Tx Power=-14.0 dBm
Rx Sensitivity=-30.0 dBm
Rx Max In Power=-14.0 dBm
Link Budget=11.0 dB
SPOEB1013-105 (SC)
1x9, 850nm, SC, MM, 3.3V
Multimode, Dual fiber, Distance = 2km,
Wavelength = 1310nm
Data rate = 100Mbps
Max Spectral Width = 400.0nm FWHM
MN Tx Power = -19.0 dBm
Max Tx Power = -14.0 dBm
Rx Sensitivity = -30.0 dBm
Rx Max In Power = -14.0 dBm
Link Budget = 11.0 dB
SPOEB1039-105 (LC)
Multi Mode
Dual Fiber
Wavelength = 1310 nm
Laser transmitter
TN PN 13300
Spectral Width Max. = 147.0nm FWHM
Min. TX Power = -19.0 dBm
Max. TX Power = -14.0 dBm
RX Sensitivity = -30.0 dBm
RX Max. In Power = -14.0 dBm
Link Budget = 11.0 dB
