DataBand E V User Manual
22
© 2012 Patapsco Designs Ltd
6. Device Window
The Device window or Connected to Device window shows the front and rear panels of the unit. The front panel shows the LED status
of the unit, which are updated in real time.
The rear panel shows the Terminal port, LAN port, Serial port and TDM ports. Click on a port to access the configuration options
relevant to the port.
6.1. Front Panel - LEDs
The LEDs on the front panel display show the status of the ports. The table below describes what the port status lights indicate.
P ort/LE D
LE D
On
Off
TDM E 1/T1 P orts 21-
24
Upper LE D Layer 1 and 2 established. Ready for operation
No connection established
Lower LE D Connections active on interface
No connections active on interface
X.21 P ort
Upper LE D 'C' control signal present on interface
No 'C' control signal present on interface
Lower LE D Connections active on interface
No connections active on interface
V.35 P ort
Upper LE D 'DTR' control signal present on interface
No 'DTR' control signal present on interface
Lower LE D Connections active on interface
No connections active on interface
LAN P ort
F D LE D
Full Duplex
Half Duplex
ACT LE D
Connected (flash when data sent/received)
No connection detected
100 LE D
100BT network detected
10BT network detected
1G LE D
1000BT network detected
No 1000BT network detected
P wr
Power Supply is running
No power connected
Run
Flash once/sec - Ready for operation
Flash fast - 4 times/sec - Ready, no config
Unit not operating
