Transition Networks C/E-PSW-FX-03, Руководство пользователя

Страница: 6 / 9

INSTALLATION
(continued)
Installing Slide-In-Module(s)
CAUTION: Wear a grounding device and observe electrostatic
discharge precautions when installing Media Converter Slide-in-
Module(s) in the Media Conversion Center. Failure to observe this
caution could result in damage to, and subsequent failure of, the
Media Converter Slide-in-Module(s).
NOTE: Slide-in-Modules can be installed in any installation slot, in any
order.
To install the Media Converter Slide-in-Module in the E-MCC-1600
chassis:
1. Remove Media Converter Slide-in-Module protective plate
from selected installation slot by removing two screws that
secure plate to front of E-MCC-1600.
2. Carefully slide Media Converter Slide-in-Module into
installation slot, aligning Media Converter Slide-in-Module
with installation guides.
NOTE: Ensure that the Media Converter Slide-in-Module is
seated firmly against the backplane.
3. Secure Slide-in-Module to E-MCC-1600 chassis by rotating
captive screw attached to Slide-in-Module clockwise into
chassis.
OPERATION
Use the status indicator LEDs to monitor C/E-PSW-FX-03 operation in
the network.
STATUS LEDS
Power Steady green LED indicates connection to
external
AC power.
100 Indicates
100MB/s
mode on
UTP/STP.
Link (RECEIVE) Steady green LED indicates UTP/STP
OR Fiber link.
Blinking green LED indicates packet reception on
UTP/STP OR on Fiber link.
FDX Steady green LED indicates full-duplex operation
on UTP/STP OR on Fiber link.
Link
FDX
Power
100
Power Modules
Media
Conversion
Center
E-MCC-1600
Power
In Use
Power
In Use
1
2
Management
Module
Power
Link
TX
RX