Setting
Default
Display Duration
Always On
Display Mode
The Port Number plus the Port Name
Scan Duration
3 Seconds
27
* If a password has been set, these settings require you to supply a proper password in
order to access them. See the
OSD Security
section, below, for details.
4.5.6 Factory Default Settings
The factory default settings are as follows:
Setting Default
4.5.7 OSD Security
In order to prevent unauthorized access to the computers, the OSD provides a pssword
security feature. If a password has been set, the OSD will request that the user specify it
before allowing entry. To set a password:
1. Press [F6] to bring up the Setup configuration menu.
2. Move the highlight bar to
Set Password
, then press [Enter].
3. Key in the new password, then press [Enter].
The password may be up to 8 characters long, and can consist of any combination
of letters and numbers (A - Z, 0 - 9).
4. Key in the new password again, in order to confirm that it is correct, then press
[Enter].
If the two entries match, the new password is accepted and the screen displays the
following message:
SET PASSWORD OK
If the entries do not match, the screen displays the message:
PASSWORD NOT MATCH
in which case you must start again from the beginning.
Note:
To modify or delete a previous password, access the Password function as in
Step 1, then use the backspace or delete key to erase the individual characters.
ptom Possible
TR-9200/9300 User Manual
