6
b. Refer to the pin assignment of USB connector (as below) and to realign the
color wires.
c. Keep the same side of wire pins facing up and insert them back into the con-
nector. Press the tab down to fully seat the wire pins.
In
se
rt
6. Connect the USB connector of the
Internal 6-in-1 Card Reader
to the USB
pin-header on the motherboard. Hardware setup is complete.
To Use the Internal 6-in-1 Card Reader
After the driver installation and hardware setup are complete, you can power on the com-
puter and start to use
Internal 6-in-1 Card Reader.
To Use with Windows 98SE, Me and 2000
1. Power on the computer. The New Hardware Found window appears (the first time
you power on the computer after installing the
Internal 6-in-1 Card Reader.
)
Wire
Pin Assignment
Red
Vcc / Power / +5V
White P-,
Data-
Green P+,
Data+
Black Gnd
Thick Black
Not Connect / Shield Ground
WARNING:
Be careful in realigning the color wires. Any error here will cause serious
damage to the
Internal 6-in-1 Card Reader.
