Manual- Weighblok Rev 1 4-2-03
4
975 Deerfield Parkway
800-503-9180
Buffalo Grove, IL 60089
847-419-1515
Configuration
The Weighblok has two menus.
The Setup menu, containing most of the indicator's functional Setup parameters, consists of 15 separate menu selections, each with its own
sub-menu of choices.
The User menu, except A5 and A10 containing most of the indicator's serial communication parameters, which not are shown in this
manual.
TO ENTER THE SETUP MENU
1.
Turn the power OFF.
2.
Put Calibration Switch to the Calibration position.
3.
Press the ON key.
4.
The display shows "F1" to indicate that the unit is in Setup menu mode.
5.
To move to a new
“
F
”
heading, use TARE or ON to move up or down.
6.
To move to the selection value, press ZERO once.
7.
Increase and decrease the value with PRINT and TARE.
8.
To save the value, press NET.
9.
Press DOT key to go back to parameter number.
10. To go back to normal menu put Calibration Switch to the Normal position.
NOTES ON THE SETUP MENU
There is an F21 sub-menu present that is for FACTORY USE ONLY!
DISPLAY
LCD Enunciator
MEANING
è
0
ç
Better known as the
“
Center of Zero
”
enunciator, this light is active whenever the displayed weight is
within
±
0.25 divisions of true zero.
N
Indicates that the indicator is displaying net weight.
G
Indicates that the indicator is displaying gross weight.
T
Indicates that a tare weight has been established in the system.
lb, kg
Indicates the unit of the displayed weight (normally disabled).
bAtt
Indicates a low battery condition. Re-charge the battery or replace if alkaline batteries.
Indicates stable weighing.
Weighblok Enunciator Definitions
ON
NET
GROSS
OFF
ZERO
TARE
