Page 3-2
F1
Grads
F2
Span Gn.
F4
Zero Range
F5
Mot. Band
F6
Dig. Filter
F7
Ovld. Limit
25 50 75 100
150
200
1 2
4
8
100%
1.9%
1d
3d 5d 10d
F8
Calib. Unit
F9
Dsp. Div.
lb
kg
500
1000
1500
2000
2500 3000
4000 5000
6000 8000
10000
12000 20000
30000 40000
50000
0.5d
1d
3d
0d
5d
F3
Zero Band
0d
2% 1d
9d
1
2
5
F10
Dec. Pt.
F17
Span Calib.
Press ZERO
key to begin
F18
Cal. View
Press ZERO
key to begin
F19
Key-in Zero
Press ZERO
key to begin
F20
Key-in Span
Press ZERO
key to begin
0 0.0 0.00
0.000 0.0000
00
F16
Zero Calib.
Press ZERO
key to begin
2%
0.25d
20%
Figure 3-2: Setup Menu Chart
3.2.3 NOTES ON THE SETUP MENU
1. There is an
F21
sub-menu present that is for FACTORY USE ONLY!
2. Detailed descriptions of the setup menu parameters can be found in Chapter 4 of this
manual.
3. The User (“A”) menu sub-menus appear when scrolling left or right from the “F” menu.
3.2.4 EXITING THE SETUP MENU
1. Power off the indicator by pressing and holding the ZERO/OFF key.
2. Position the shunt block as shown at right.
JP4
Note:
On certain models, the shunt block position will be exactly the opposite.
3. Power on the indicator by pressing the PRINT/ON key. The display will go through a digit
check, then settle into Normal Operating mode. All front panel keys will now return to their
normal mode of operation.
3.3
USER (“A”) MENU
3.3.1 ENTERING THE USER MENU
1. Enter the Setup (“F”) menu by following the directions in Section 3.2.1 or 3.2.2.
2. Use the right or left directional keys shown in Figure 3-3 to move right or left in the
Setup (“F”) menu until the indicator shows ” A 1”.
