Trango Systems Flacon Plus, Инструкция по установке и эксплуатации, Страница: 35 / 48

Copyright © 2000 Trango Systems, Inc. (All rights reserved)
34
Configuring the Falcon PLUS™ Receiver:
Via the TrangoLink interface panel for the VRX5900
receiver, the user can configure the following settings:
MENU CONTROLS:
File: Choosing this pull-down menu brings up three
options:
Sound: This toggles the PC sound on and
off, so that the PC can beep (or not) if a
change in any of the indicators is received.
Select Port: This selects the serial port
through which the PC is connected to the
transmitter or receiver. The cable required to
connect may be purchased from your Trango
Systems sales representative.
Exit: Exits TrangoLink.
Link Verification: This option brings up a dialog box by
which the Link Verification Code can be set. This is a
32-bit code sent from the transmitter to the receiver to
verify that the signal is being received from the proper
location. The link verification codes on the transmitter
and receiver must match for reception of alarms or low
battery signals. If the codes do not match video will still
be received, but the user will be notified that it is not
coming from the proper location.
Pass-Through Mode: Choosing this pull-down menu
brings up the following dialog box shown in Figure 7
through which the data rate and parity can be chosen.
To use this function, the Stereo/Alarm switch on the
transmitter and receiver must be set to “Alm/Data Mode
On.”