Trango Systems Flacon Plus, Инструкция по установке и эксплуатации, Страница: 28 / 48

Copyright © 2000 Trango Systems, Inc. (All rights reserved)
27
Troubleshooting the
Falcon PLUS™ System
INTERFERENCE
If interference such as lines in the pictures is observed,
changing the transmission channel may cure the
problem.
Also, AC generators in close proximity to the transmitter
or receiver may cause lines in the picture. Move the unit
away from the source of the interference.
NO PICTURE
Check that the transmit and receive channels are set the
same, and make sure the transmitter is not in Standby
mode (slow, blinking LED), or that the battery is not low
(fast, blinking LED).
Verify all connectors are tight.
POOR PICTURE QUALITY
Raise transmitter and receiver antennas above ground
and away from obstacles and traffic, including foot traffic.
Use an optional high-gain dish antenna on the receiver.
Verify all connectors are tight. Shorten the receiver
antenna feed cable.
VIDEO TOO DARK
Make sure that any monitors/peripheral equipment
connected to the video source are set to high impedance
termination since the VTX5900 has a built-in 75
Ω
termination.