Trango Systems Flacon Plus, Инструкция по установке и эксплуатации, Страница: 18 / 48

Copyright © 2000 Trango Systems, Inc. (All rights reserved)
17
The Status LED will blink for about 1 minute to allow the
operator to leave the area. During this time the alarms
will not be sent to the receiver. After 1 minute, the alarm
inputs will be active and the status LED will then blink
every 2-3 seconds to indicate that the unit is in Secure
Standby mode.
To exit Secure Standby mode, momentarily press the
Toggle/Standby switch or use the TrangoLink software.
After exiting Secure Standby mode, the active channel
LEDs will be lit to indicate the transmitter is now
continuously transmitting again.
Standby Mode -- Power Save Standby Mode:
In Power Save Standby mode, the transmitter will awaken
(enter Normal mode) for a user-selectable amount of time if
an alarm is received over the Alarm 1 input. After this time
has expired, the transmitter will reenter Standby mode. The
amount of time after which the transmitter will reenter
Standby mode can be set to any value between 1 and 255
minutes using the TrangoLink software. If zero is entered,
the transmitter will be in Secure Standby mode, and will not
reenter Standby mode after awakening. More information
can be found in the TrangoLink section of this manual.
When the transmitter has been placed in Power Save
Standby mode, the Alarm 1 input is treated as normally-
closed. An open condition on this input will awaken the
transmitter for the preset amount of time. The state of the
Alarm 2 input does not affect the transmitter in Power Save
Standby mode.