Trango Systems Flacon Plus, Инструкция по установке и эксплуатации, Страница: 17 / 48

Copyright © 2000 Trango Systems, Inc. (All rights reserved)
16
VTX5900 Transmitter Operation:
Changing Channels:
To change channels, simply depress the Toggle/Standby
switch momentarily until the LED(s) for the desired
channel is lit up. Remember to change the receiver
channel as well, since it is not automatically changed
when the transmitter channel is changed. As a rule of
thumb, the first 6 systems operating along the same
transmission path should be set to use even channels
(2,4,6,8,10,12). If more than 6 systems are required
along the same transmission path, use opposite
polarization antennas and then set the units to operate
on the odd channels (1,3,5,7,9,11). Contact Trango
Tech Support for additional help on setting the correct
configuration for your application.
Standby Mode -- Secure Standby Mode:
In this mode of operation the transmitter:
1. stops transmitting over the air completely by
shutting down the majority of its circuitry to save
power, and
2. waits to be returned to Normal mode by one of
the following:
•
a change in either Alarm input,
•
the Toggle/Standby switch, or
•
the TrangoLink software.
To enter Secure Standby mode, press and hold the
Toggle/Standby switch for 2 seconds or use the
TrangoLink software (See the TrangoLink section of this
manual for more information).