Trane Voyager RT-SVX17C-EN, Установка, эксплуатация и обслуживание

Страница: 74 / 80

74
Component Failure Mode (Continued)
COMPONENT FAILURE RESPONSE NORMAL RANGE DIAGNOSTIC
If RTRM senses a zone temp
input and then it is lost,
(ZTEMP) Zone 1. No Heating or Cooling -40 TO 150 F CV Cool Failure Output
Temperature Sensor ZSM "Fan" selection 346K to 2.1K at RTRM J6-8 to J6-6
CV or VAV during switch operates IDM "COOL" LED Blinks
Unoccupied mode. during Unoccupied Mode at ZSM
TC01, TCO2, TC03 Heat goes off, IDM runs Normally Closed Heat Failure Output
High Temp Limit continuously. Open 135 F at RTRM J6-7 to J6-6
Reset 105 F. "HEAT" LED Blinks at ZSM.
(LPC1) Low Pressure Compressor CPR1 Open 7 PSIG Possible Cool Failure at
Control will not operate. Close 22 PSIG. RTRM J1-8 to Ground, 0 VAC.
"COOL" LED Blinks at ZSM.
(LPC2) Low Pressure Compressor CPR2 Open 7 PSIG Possible Cool Failure at
Control will not operate. Close 22 PSIG. RTRM J3-2 to Ground, 0 VAC.
Dual Circuits Only "COOL" LED blinks at ZSM.
(CCB1) Compressor CPR1 Normally Closed Cool Failure Output
will not operate. range varies by unit. at RTRM J6-8 to J-6
"COOL" LED blinks at ZSM.
(CCB2 or CCB3) Compressor CPR2 or Normally Closed Cool Failure Output
Compressor Overload CPR3 will not operate. range varies by unit at RTRM J6-8 to J-6
"COOL" LED blinks at ZSM.
(HPC1) High Pressure Compressor CPR1 Open 425 psig Cool Failure Output
Control will not operate. Close 325 psig at RTRM J6-8 to J-6
"COOL" LED blinks at ZSM.
(HPC2) High Pressure Compressor CPR2 or Open 425 psig Cool Failure Output
Control CPR3 will not operate. Close 325 psig at RTRM J6-8 to J-6
"COOL" LED blinks at ZSM.
(WTL1) Winding Compressor CPR1 Normally Closed Cool Failure Output
Temperature Limit will not operate. at RTRM J6-8 to J-6
"COOL" LED blinks at ZSM.
(WTL2 or WTL3) Compressor CPR2 or Normally Closed Cool Failure Output
Winding Temperature CPR3 will not operate. at RTRM J6-8 to J-6
Limit "COOL" LED blinks at ZSM.
(CC1) Compressor Compressor CPR1 Varies by unit Cool Failure Output
Contactor will not operate. at RTRM J6-8 to J-6
24 VAC coil "COOL" LED blinks at ZSM.
(CC2 or CC3) Compressor CPR2 or Varies by unit Cool Failure Output
Compressor Contactor CPR3 will not operate. at RTRM J6-8 to J-6
24 VAC coil "COOL" LED blinks at ZSM.
*NONE* = No LED indication