INSTRUCTION MANUAL
UG30 CONTROL
4 (44)
mP30-UG30 - Rev. 1.5 - Date: 18-03-2004
EN
PROGRAM IDENTIFICATION
This manual describes the characteristics of the standard
UG30 and mP30
control for conditioners.
The software version can be read by repeatedly pressing key
until your reach the "
Hr
" parameter; this
information must be supplied to the technical service centres when they are called in for a job.
Version
Parameter
1.6
Hr
The setting of some parameters on a
special
unit
version may differ from those described in this manual.
WARNINGS
Do not install the controls in places with the following characteristics:
- relative humidity above 80%;
- exposed to aggressive and polluting atmospheres (e.g.: sulphur or ammonia gasses, salt mists,
fumes) to avoid corrosion and/or oxidation;
- high magnetic and/or radio frequency interference (therefore, avoid installing units near transmitter
aerials);
Cut power before beginning work on the circuit in the case of assembly, maintenance or
replacement jobs.
In general, all the instructions found in the unit’s Installation, Use and Maintenance Manual apply.
WARNING:
In direct expansion air-conditioners with a three-phase power supply, the controller's power may be cut if
the phase sequence relay (RSF) is tripped.
