Installation and operating manual – TUM1072
TEF 2440
Perimeter / Obstruction light
The safety wire should be in place and the two electrical wires for power to the LED’s should be correctly positioned
(+ and -). The input power 100-230 VAC should be terminated as indicated inside the lamp.
For the 24VAC/VDC version, connect power to the connection block.
Ensure the globe gasket is clean and properly aligned around the bottom of the globe assembly. Carefully
position the globe onto the lamp body and ensure that no wires is located between the lamp body and the globe
assembly. Place the globe ring over the globe and ensure the four screws enter the recessed nuts in the lamp body.
Slightly tighten the screws in a cross pattern to ensure that the globe lies straight, and the pressure on the globe
gasket is distributed evenly. Tighten all four screws until the globe is firmly positioned.
Power tools shall not be used in any circumstances!
