11
T23
Series User Manual
For more information about Tramigo tracking products, please visit www.tramigo.com. For distributor, re-seller and
partnership opportunities, email
4.4
First Use
•
Please read the Quick Start Guide before proceeding.
•
Ensure that your T23 Series has a working SIM installed.
o
Check that the SIM has not run out of credit (test the SIM in a phone to make
sure it can send and receive SMS)
o
Check that the SIM Lock code is turned off.
•
Charge your unit for 3 hours via USB. Use the T23 Series USB cable to
connect the unit to PC or USB charger.
•
Check the T23 Series Power LED behaviour. Charging on low battery state will turn
power light on solid yellow then will turn to solid green when enough charge was
gained. When fully charged, the green light will change from solid green to
blinking
green (every 5 seconds blink).
If the unit has been in storage it may take 15
minutes for the power light to turn on.
•
Check that the GSM (red) LED is off.
•
Check that the GPS (blue) LED is off, if not refer to next step.
•
Take your T23 Series outside to where you have a clear view of the sky. After a minute
or two, the blue GPS light will turn off indicating that your T23 Series now knows its
location.
•
After your T23 Series has been installed into the vehicle you are ready to become the
‘Owner’. Owner authority has access to all the T23 Series commands and features.
•
Send the following SMS to your T23 Series in upper or lower case:
OWNER
This is the same with Owner,0000 from previous registrations.
•
T23 Series will respond with a text message stating:
Tramigo: Owner, +635551234 registered, 09:25 April 14
This means that you are now the Owner of T23 Series and it will accept any
commands that you issue to it, providing they come from the same mobile phone number
as you used for this setup.
•
If you plan to use your T23 Series as a portable device send the command:
Set,sleep1repeats,6
•
At this point you should change your T23 Series password to ensure a high level of
security. You can do this by sending a command via text message to T23 Series – old
password is 0000 by default:
PASSWORD,<old_password>,<new_password>
PASSWORD,0000,903WOOD
•
The new password that you specify can be up to 20 digits long using letters and
numbers. If your command is successful, T23 Series will reply with:
Tramigo: Password, changed to 903WOOD, 09:25 Jan 14
•
You may now wish to personalise your T23 Series by specifying a name. The name
shows in the start of all SMS the unit sends to you. To do so, send a command via text
message to T23 Series:
NAME,Julie Car
•
The new name that you specify can have a maximum of 15 characters. If your
command is successful, T23 Series will reply with:
Julie Car: Name, OK, 09:25 Jan 14
T23 Series is now ready for use. Try sending a
FIND
command via text message to receive a
message describing the position of your vehicle. See how to add other users in the
Authorization
section. See the
Features
section to explore the capabilities of your T23 Series
device.