84
TRAK Machine Tools
Southwestern Industries, Inc.
TRAK TRL Lathe, ProtoTRAK RLX CNC Safety, Installation, Maintenance, Service & Parts List
6.
Using an engine hoist or chain hoist, attach it to the eye bolt. Remove the 6 screws that mount
the turret to the mounting base. Slowly raise the hoist until the turret is clear of the mounting
base. Slowly move the hoist away from the machine. Lower the turret onto a cart, pallet or the
shipping crate the unit was shipped in.
7.
To reinstall reverse the above steps. Insure all mounting surfaces are clean and free of chips or
debris before mounting the turret. Turret is not pinned so it will need to be aligned for maximum
accuracy.
6.1.4 Troubleshooting the Turret
The following fault messages will appear on the screen when there is a problem with the turret.
Fault 85 – Impossible Tool Position
This message will appear if the turret goes to a tool number that you did not select. For
example, the operator chose Tool 2 and the turret went to Tool Station 6. To fix this problem,
re-initialize the system by choosing Service Code 147. Contact Southwestern Industries
Customer Service.
Eye bolt used for
lifting turret.
