60
TRAK Machine Tools
Southwestern Industries, Inc.
TRAK TRL Lathe, ProtoTRAK RLX CNC Safety, Installation, Maintenance, Service & Parts List
should be no continuity between pins 2 and 7 when the low gear switch is pushed and continuity when the
switch is released in “Low speed” handle position. The spindle control electrical box gear LEDs will indicate
GEAR1 for High Speed and GEAR2 for Low Speed and in neutral position both LEDs will remain OFF.
4.8 Service Codes
Service codes are broken down into the 5 following categories: software, machine setup, diagnostics, user
options/defaults and lubrication pump control.
All Service Codes are accessed in the SET-UP Mode by pressing the soft key for “SERV CODES”. The service
codes can be found under one of the headings listed on the main screen. Press the heading you want to
access the code in question. If you know the code #, press the CODE # softkey and it will take you directly
to the code in question. Press CODE #, enter the number you want, press SET.
4.8.1 Software Codes
The following codes pertain to software functions in the control. To get to any of these codes go to
Service Codes, press “A” and press the code you wish to view.
Note - If you are working with the SWI Customer Service Group, write the values down for Code 33.
These values will be valuable for troubleshooting.
4.8.1.1
CODE 33: Software ID
The Code 33 is the software identification procedure. The two types of software in the control
include:
Software Version
- the version of the system you have installed
Firmware Version
- the version of firmware software that is responsible for control to servo
interface.
Converter Version
– the version of software that is responsible for converters and options.
Operating System Version
– shows the version of the XP operating system
4.8.1.2
CODE 141: Load Configuration File to the Computer
This code allows you to load your configuration file from a selected drive to your hard drive. The
configuration file consists of items such as calibration and backlash constants. This code is used
when a computer module or hard drive has been replaced.
4.8.1.3
CODE 142: Save Configuration File from the Computer
This code allows you to save your configuration file to an external thumb drive. The configuration
file consists of items such as calibration and backlash constants. This code is used when a computer
module or hard drive needs to be replaced. This stores the configuration file from the hard drive to
an external thumb drive. It is a good idea to do this code after the machine is initially setup so
these values can be saved and used in the future. If the computer or hard drive fails, then you will
not have the ability to save the configuration file and the machine will need to be re-setup when the
computer or hard drive is replaced.
4.8.1.5
CODE 316: Update Master Software
Load upgrade disk in an external drive and press this service code. New software will automatically
download and control will reboot.
