TRAK Machine Tools
Site Preparation Guide
TRAK DPMRX3
F16467-45 Rev 020921
Page 1 of 4
Before an Authorized Field Service Technician can perform the machine’s final checkout, the following requirements must be me
t:
•
The machine must be in position and placed on its rest pads
•
To offload the machine, a 6
000 lb. forklift with 6’ extension is required.
•
The machine must be leveled (refer to installation and service manual).
•
The machine must be wired (refer to the installation and service manual).
•
The machine must have air hooked up if power drawbar is installed (see the
installation and service manual).
•
The machine must be cleaned. Remove all grease from the way surfaces.
Space & Weight
•
Floor area = 102.3
”
x 96.6
”
•
Height = 96.75
”
•
Footprint = 2
4”
x 43.3
125”
•
Net (approx.) Weight = 4100 lbs.
•
Shipping (approx.) Weight = 4400 lbs.
•
Pallet Size =
76” x 76”, 8” thick
•
Allow clearance at the rear of the mill to open and
work on the electrical box.
•
A solid and level foundation to maintain
approximately 4100 lbs plus the weight of the
workpiece (maximum total 5500 lbs) is required.
Six leveling screws are provided.
Electrical
•
Machine is only available in the 208 VAC
configuration (200 to 240V is acceptable). A
separate 208V, 35 amps, 60 Hz, 3 phase circuit is
required. For shops with 440 VAC, a step-down
transformer to 208 VAC must be used. The
transformer must be sized to carry a load of 35
amps minimum.
•
Machine tool must be earth grounded.
Air (for optional Power Drawbar)
•
¼” NPT connection
•
Air pressure not to exceed 100 psi
•
17.5 SCFM or 2.5 CFM at 90 psi
DPMRX3 Machine Footprints
A
Overall Width (With Mechanical Handwheel)
99.625”
A1
Overall Width (With Electronic Handwheel)
102.25”
B
Overall Length (With Mechanical Handwheel)
92.25”
B1
Overall Length (With Electronic Handwheel)
96.625”
C
Bed Width
24”
D
Bed Width between leveling screws
21.7”
E
Distance between leveling screws
18.75”
E1
Distance between leveling screws
17.5”
F
Bed length
43.3125”
