Wiring Loom Fitting Instructions
To Suit Hyundai Tucson TL
Part Number 201365-WL
Page
3 of 3
Issue Date
10-09-15
Cequent Customer Service
Ph: 1800 812 017 Fax: 03 9797 3299
Email: [email protected]
Post: PO Box 4050, Dandenong South VIC 3175
1. Fold down the rear passenger seats.
2. Remove the luggage compartment floor, tools jack and jack bracket.
3. Remove the rear trim and remove the two fasteners.
4. Remove the four fasteners from each side of the luggage compartment trims and then
dislodge the luggage compartment trims.
5. Remove rear passenger RHS kick trim.
6. Remove the driver’s door sill trim.
7. Remove the bonnet handle and then remove the driver’s kick panel trim.
8. On the RHS of the luggage compartment, locate the RHS rear quarter existing
grommet hole (1) and drill out to Ø30mm. Apply rust inhibitor after drilling (not
supplied). If the grommet hole is occupied, pick a nearby location on the vehicle sheet
metal to drill through.
9. From the vehicle interior, retrieve the vehicle RHS tail light connector.
10. Route the trailer patch (P/No:201365-WL) connectors to the retrieved RHS tail light
connector and connect to the mating trailer patch connector.
11. Route the remaining trailer patch connector through the vehicle grommet hole until the
trailer patch grommet is seated correctly.
12. Route the trailer patch LHS branch towards the LHS vehicle tail light area and then
connect the trailer patch connector to the mating vehicle harness tail light connector.
13. Pierce a small hole into the vehicle grommet and route the trailer patch reverse terminal
into the vehicle.