Towbar Fitting Instructions
To Suit
HYUNDAI TUCSON TL & TLe SERIES
Part Number
QTHY264L
Rating
1600/140
kg
PLACE THESE INSTRUCTIONS IN THE VEHICLE’S GLOVEBOX AFTER INSTALLATION IS COMPLETED
Rev: A Page 3
Issue Date:
21-04-2016
Cequent Customer Service
Ph: 1800 812 017 Fax: 03 9898 3299
Email: [email protected]
Post: PO Box 4050, Dandenong South VIC 3175
INSTRUCTION:
1. Remove plastic trim cover adjacent to tail light assembly.
Repeat for opposite side of vehicle.
2. Remove 2x Screws securing taillights to vehicle. Remove tail light assembly.
Repeat for opposite side of vehicle.
3. Remove 2x push rivets from taillight cavity.
Repeat for opposite side of vehicle.
4. Remove 4x Screws within rear wheel arch.
Repeat for opposite side of vehicle.
5. Remove 2x Screws adjacent to chassis rail, securing rear impact beam to rear the panel.
Repeat for opposite side of vehicle.
6. Remove 3x push rivets under vehicle behind rear wheel arch and 1x push rivet from within rear wheel arch.
Repeat for opposite side of vehicle.
7. Remove plastic undertray from behind rear wheel arch.
Repeat for opposite side of vehicle.
8. Carefully unclip and remove rear bumper; disconnecting any applicable wiring looms.
9. Remove 3x push rivets securing impact beam bumper tabs to bumper.
10. Remove 2x clips securing top of impact beam to bumper.
11. Where applicable, release smart key antenna from impact beam.
12. Detach wiring from impact beam and remove and discard impact beam from rear bumper.
13. Loosely secure sidearm to side face of chassis rail using 2x M10 Screws, complete with 1x Flat washer per Screw.
Repeat for opposite side of vehicle.
14. Loosely secure sidearm to underside of chassis rail using 2x M10 Screws, complete with 1x Flat washer per Screw.
Repeat for opposite side of vehicle.
15. Loosely secure welded assembly to sidearms using 4x M12 Screws per side arm, complete with 2x Flat washer and
1x M12 Nut per 2 of the Screws, and 1x Flat washer per the remaining 2 Screws.