Tradesman BTS10W4, Руководство пользователя

Страница: 13 / 28

1
2
1
2
9
8
ASSEMBLY
BLADE GUARD ASSEMBLY (FIG. 11, 12, 13)
1. Set the blade to maximum height and the tilt to zero degrees
on the bevel scale with the hand wheels. Lock the blade lock
knob.
2. Place the external toothed lock washer (1), a steel flat washer
(2) and a spring washer (10) onto the long hex head bolt (3).
Insert the bolt into the splitter bracket (4) as shown. (Fig. 11)
Fig. 11
Place the oval washer (5) on the pivot rod (6). (Fig. 12)
3. Install the bracket assembly (4) at the rear of the saw table
and snugly – do not tighten. Thread the bolt (3) into the
internally threaded pivot rod.
NOTE: The splitter is removed from the illustration
for clarity.
Fig. 12
4. Hold the blade guard arm up (7). (Fig. 13)
5. Using a straight edge, check to see if the blade guard splitter
(8) is aligned with the saw blade (9).
6. If straightening adjustment is necessary, loosen the bolt (3)
and shift the splitter assembly to right or left, or rotate.
7. When the splitter is properly aligned with the saw blade,
tighten the bolt, very tight.
8. If height adjustment is necessary, loosen the knob (11) and
raise the splitter assembly to the desired height and tighten
the knob. (Fig. 11)
NOTE: The splitter must always be correctly aligned so that
the cut workpiece will pass on either side without binding or
twisting.
CAUTION!
Improper splitter alignment can cause “kickback” and
serious injury.
INSTALLING THE TABLE EXTENSION FENCE (FIG.
14, 15)
NOTE:
A. For ripping 10” ~ 14” workpiece, the extension fence has
to be installed in the IN-RIP position (Fig. 14). Raise the
fence to a position that just clears the table surface and
secure in place using lock handles (1).
B. For ripping 14” ~ 24” workpiece, the extension fence has
to be installed in the OUT-RIP position (Fig. 15).
1. Install the locking handles (1) on the aluminum extension
table.
2. Place the table extension fence (2) on the aluminum
extension table.
3. Raise the fence to the desired height and tighten the lock
handles (1).
Fig. 14
Fig. 15
Fig. 13
13
Kickback pawl
3
7