Tradesman BTS10W4, Руководство пользователя

Страница: 19 / 28

OPERATION
BEVEL RIPPING
This cut is the same as ripped except the blade bevel angle is
set to an angle other than “0”.
CAUTION!
Cut only with the workpiece and the fence on the right side
of the blade.
RIPPING SMALL PIECES
CAUTION!
Avoid injury from the blade contact. Never make through-
saw cuts narrower than 1/2” wide.
1. It is unsafe to rip small pieces. Instead, rip a larger piece
to obtain the size of the desired piece.
2. When a small width is to be ripped and your hand cannot
be safely put between the blade and the rip fence, use one
or more push sticks to move the workpiece.
CROSSCUTTING (FIG. 29)
CAUTION!
To prevent serious injury:
Do not allow familiarity or frequent use of your table
saw to cause careless mistakes. Remember that even a
careless fraction of a second is enough to cause a severe
injury.
Keep both hands away from the blade and the path of the
blade.
1. Remove the rip fence and place the miter gauge in the
left side groove.
2. Adjust the blade height so it is 1/8” higher than the top of
the workpiece.
3. Hold the workpiece firmly against the miter gauge with
the blade path in line with the desired cut location. Move
the workpiece to one inch distance from the blade.
4. Start the saw and wait for the blade (1) to come up to full
speed.
5. Keep the workpiece (2) against the face of the miter gauge (3)
and flat against the face of the gauge and flat against the table.
Then slowly push the workpiece through the blade.
(Fig. Y)
6. Do not try to pull the workpiece back with the blade turning.
Turn the switch OFF, and carefully slide the workpiece out
when the blade is completely stopped.
Fig. 29
BEVEL CROSSCUTTING (FIG. 30)
This cutting operation is the same as crosscutting except
the blade is at bevel angle other than 0°.
1. Adjust the blade (1) to the desired angle, and tighten
the blade bevel lock knob.
2. Always work to the left side of the blade. The miter
gauge (3) must be in the left side groove (2). It cannot
be used in the right side groove unless the miter angle
is very sharp, as it will interfere with the blade guard.
Fig. 30
19