ADJUSTMENTS
Additional blade adjustments (FIG. 23)
1. If the front and rear measurements are not the same, remove
the combination square and loosen the four adjusting screws
using a 4mm hex key (1) on the top of the table about a half
turn.
NOTE:
If adjusting screws are too tight, turn machine up
side down and loosen corresponding nuts with a 10mm
wrench.
2. With a folded piece of cardboard covering the blade to
protect your hands, move the blade carefully to the left or
right as much as needed to align the blade correctly.
3. Tighten the four screws (1) and re-measure, as described in
steps 4 to 9 in the prior section.
4. If sufficient adjustment cannot be made by the four adjusting
screws (1), then also loosen the two adjusting screws (2).
Loosen these screws only if necessary. Repeat step #2.
5. Recheck blade clearance making sure that the blade does not
hit the table insert or other parts when at the 90° and 45°
settings.
6. Tighten all screws.
Fig. 23
16
Содержание BTS10W4
Страница 7: ...CARTON CONTENTS 7 A M S R B F G C D E Q P K J I H O N L ...
Страница 25: ...25 ...
Страница 27: ...MOTOR DIAGRAM 27 ...