OXYGEN AND FUEL CONSUMPTION
The rate of oxygen and fuel consumption
is strongly influenced by the tip selection,
flame size and nature of work.
As an estimate:
7
TEMP
OXYGEN
FUEL
TIP SIZE
OXYGEN TIME
FUEL TIME
3000°C
110 L
Part No:
211423
TF/ULTRA
GAS 400 g
Part No:
326439
40 L/hr
Part No: 211445
2 hr 30 min
14 hr 30 min
50 L/hr
Part No: 211456
2 hr
11 hr 30 min
70 L/hr
Part No: 211467
1 hr 40 min
9 hr
100 L/hr
Part No: 211478
1 hr 10 min
6 hr 30 min
WORK PREPARATION
When using this equipment proper preparation
is ALWAYS required. This includes:
1. Cleaning the area to be worked on
with sandpaper or a wire brush.
2. Removing any paint or other materials
that may inhibit bonding.
3. Using flux when required.
4. Understanding what materials are being
worked with and using the appropriate
welding, brazing, or soldering rods or solder.
MAINTENANCE
• Use only genuine replacement parts.
• Never use equipment if any
components appear damaged.
• Important: Do not carry out any type of
operations on single parts; it may result in
serious risks for the user. If the equipment
does not function properly, contact
Customer Service on 1300 555 197.
• Carefully follow instructions provided.
• For maintenance and storage of
protective glasses, see the instructions
for use provided with them.
• Regular inspection of equipment is
required to ensure correct function.
• Many of the components used in this
equipment cannot be repaired and are
designed this way to ensure safety.
WARNING
• To avoid any injury or damage, only ignite
the torch when it is clear of hands, clothing,
or any other combustible materials.
• The torch becomes extremely hot
during and after operation. Care must
be taken to avoid accidental burns.
• Ensure the flame is completely
extinguished after use.
• Protect from direct sunlight. Do not expose
to temperature above 49°C/120°F.
• The kit is designed to use with flammable
gas under pressure. Do not disassemble
puncture or incinerate cartridges after use.
• For maximum protection always wear welding
goggles (supplied with this kit), gloves and
other appropriate safety equipment.
• Keep out of reach of children.
• The installation and adjustment made in
the factory of this equipment should not be
changed. Altering, removing components and
/or using parts which are not recommended
by the manufacturer can be very dangerous.
• It is strongly recommended that you only use
original parts made for this equipment, oxygen
cartridge Part No: 211423, fuel cartridge
Part No: 326439 or 326438. Using different
types of cartridges can be dangerous. Read
the safety section and these instructions
carefully before using this equipment.
