TO ASSEMBLE
1. Ensure the fuel regulator valve is off
(turn knob
4
fully clockwise to
-
).
2. Make sure the seal inside the fuel
regulator is seated properly and
is in good working condition.
3. Screw the fuel regulator
4
onto the fuel
cartridge
8
in a clockwise direction,
hand tighten only. DO NOT OVER TIGHTEN.
4. Ensure the oxygen regulator valve is off
(turn knob
3
fully clockwise to
-
).
5. Make sure the seal inside the oxygen
regulator is seated properly and
is in good working condition.
6. Screw the oxygen regulator
2
onto the
oxygen cartridge
7
in a clockwise direction,
hand tighten only. DO NOT OVER TIGHTEN.
NOTE: It may be easier to screw the cartridges
onto the regulators in a clockwise direction.
Hand tighten only. DO NOT OVER TIGHTEN.
IMPORTANT: Before lighting the flame
make sure that all connections have been
properly made. Check that there are no
leaks with the appropriate gas leak spray
or a solution of soapy water. Repeat this
operation every time a cartridge is replaced.
STAND ASSEMBLY INSTRUCTIONS
This equipment is supplied with a
metal stand / cartridge holder.
1. Once you have connected the cartridges
to the regulators, slide each cartridge into
one side of the stand, making sure that the
butterfly nut on the back of the stand is
screwed onto the bolt just enough to hold
the front metal cartridge strap in place.
2. Once you have both cartridges inserted
into the stand, tighten the butterfly nut
until it stops. Do not over tighten as you will
damage the butterfly nut or the centre bolt.
3. When inserting the cartridges make sure that
the hoses are not tangled, and the cartridges
are put on the correct sides of the stand
in order for the hoses not to be crossed.
3
