PRODUCT IDENTIFICATION
1. Metal carry stand/cartridge holder
2. Oxygen pressure regulator (blue knob)
3. Oxygen pressure gauge
4. Fuel pressure regulator (orange knob)
5. Fuel pressure gauge
6. Flash back arrestors
7. Oxygen cartridge (not included)
8. Fuel cartridge (not included)
9. Hose
10. Torch handle
11. Torch oxygen control knob (blue)
12. Torch fuel control knob (orange)
13. Lance
14. Replaceable tip
15. Welding goggles
(Do not use with electric welding)
16. Ignition striker
15
2
3
1
7
8
6
6
6
4
5
GENERAL INSTRUCTIONS
A gas such as TF/ULTRA GAS - Performance Gas – MAPP
®
Replacement
*
or Propane
(referred to as fuel in this document) is liquefied in the cartridge and therefore the
contents of the cartridge can be estimated by the weight of the cartridge.
Oxygen is compressed gas within the cartridge and the difference between the
weight of a full cartridge and of an empty one is not easily recognised.
The oxygen regulator is fitted with a high- pressure gauge that allows you to check the
contents of the oxygen cartridge. As the oxygen is stored in a gas state it is impossible to
ascertain the contents of the oxygen cartridge by the weight of it. When the oxygen cartridge
is full, the gauge should read 110 bar of pressure. This indicates that the oxygen cartridge
is full. When the oxygen cartridge is empty the gauge should read 0 bar of pressure.
The fuel regulator is fitted with a low-pressure gauge that allows you to check
and control the delivery of the fuel released from the fuel cartridge.
The quoted approximate use times have been calculated considering a correct mixture
of oxygen and gas. Incorrect mixtures could alter these times considerably.
When storing this kit, we recommend removing the regulators from the cartridges completely.
16
13
14
12
11
10
2
9
*MAPP
®
is a registered trademark of the Linde Group
6
6
x2
