TracVision M3 User’s Guide
30
Chapter 4 - Setup
9.
Repeat steps 7 and 8 for the remaining satellites you
want to install. If you don’t need to install four
satellites, select NONE instead.
Once you have selected all four satellites, or you have
selected NONE, the antenna installs the selected
satellite(s) then restarts.
10.
Pay close attention to the display during antenna
startup. The display will show the recommended LNB
skew angle setting for your selected satellite(s) and
position. See
11.
Set up your satellite TV receiver for the same satellites
that you set up in the antenna. See your receiver
owner’s manual for details.
CONFIGURING ANTENNA
RESTARTING ANTENNA
Be sure to adjust the antenna’s LNB to the correct skew
angle, as reported by the interface box during startup. See
“Setting the LNB Skew Angle” on page 31
for skew
adjustment instructions.
IMPORTANT!
Be sure to set up satellites in the receiver
in the same order
that you set them up in the antenna. In other words, SAT 1
(or A) in the receiver must be set to the same satellite as
SAT 1 in the antenna, and SAT 2 (or B) in the receiver must
be set to the same satellite as SAT 2 in the antenna.
IMPORTANT!
