Installation
54-0198
47
Entering User-defined Satellite Data
Enter the following antenna commands to configure your user-
defined satellites.
If you’re using HyperTerminal, type the command
in the HyperTerminal window then press
Enter
. If you’re using the
KVH Flash Update Wizard, type the command in the “Command” box,
then press
Enter
.
1. Enter the SATCONFIG parser command as follows:
Command:
SATCONFIG,USERX,YYY,Z,D,L<Enter>
(<Enter> indicates press the Enter key)
Where:
X = 1 (USER1 satellite) or 2 (USER2 satellite)
YYY = longitude (0-180)
Z = E (East) or W (West)
D = decoding type (0 = test, 1 = DSS-A,
2 = DSS-B, 3 = DVB)
L = LNB polarization (C = circular, L = linear)
Function:
configures one of the user-configurable satellites
with the longitude provided
Response:
if valid entry, echoes the input data
if invalid entry, returns error message
2. Type
@DEBUGON<Enter>
to enter DEBUG mode.
3.
Enter the satellite’s transponder information as follows:
Command:
@SATCONFIG,X,N,F,S,C,ID,P,B,D<Enter>
Where:
@SATCONFIG = directs data to the RF Board
X = satellite location (A = USER1, B = USER2)
N = satellite table # (98 = USER1, 99 = USER2)
F = frequency in MHz (either 00000 or within the
range 10700 - 12700)
S = the satellite transponder symbol rate in
Mbit/second (01000 - 29999)
C = the FEC code (e.g., 12, 23, 34, 56, 67, 78)
ID = the satellite network ID in hexidecimal format
(0x####)
P = the LNB polarization (v = vertical,
h = horizontal, r = right, l = left)
B = the LNB down conversion frequency (l = low,
h = high, G = Latin America, U = USA)
D = decoding type (1 = DSS-A, 2 = DSS-B,
3 = DVB)