TracVision C3, Руководство по установке

Страница: 12 / 24

13
Follow the steps below to wire your receiver.
a. Connect the RF1 cable from the antenna to
the “Satellite In” connector on the receiver
(see Figure 20).
b. Make sure the receiver is grounded. If the
receiver has a 2-prong power plug, run a
ground wire from the receiver’s chassis to a
suitable ground point. If a potential exists
between AC and DC grounds, connect the
wire to the switchplate’s DC return instead.
Figure 19: Augat IT1000 Connector Installation Tool
If you cut the RF cable, be sure to terminate it
with Snap-N-Seal
® F-connectors using an
Augat IT1000 connector installation tool
(KVH part #19-0242). Screw-on, push-on,
twist-on, and other low-quality connectors
will degrade system performance.
IMPORTANT!
Receiver
SATELLITE IN
OUT TO TV
TV ANT/CABLE IN
AUDIO VIDEO S-VIDEO PHONE JACK
R L
SATELLITE
IN
RF1
Antenna
Vessel
AC Ground
Figure 20: Linear Receiver Wiring
Wire the Receiver 10
Linear Only