TRACTION MPL50-Li, Инструкция по эксплуатации

Страница: 2 / 180

5404-MAN-001-EN-0D
⚠
Safety Guidelines
1. General Safety Precautions
SAVE THESE INSTRUCTIONS.
1.1. IMPORTANT SAFETY INSTRUCTIONS. IT IS OF
UTMOST IMPORTANCE THAT BEFORE USING
YOUR BATTERY CHARGER, YOU READ THIS
MANUAL AND FOLLOW THE SAFETY AND
OPERATING INSTRUCTIONS EXACTLY.
1.2. Use of an attachment not recommended or sold
by the Battery Charger manufacturer may result
in a risk of fire, electric shock, or injury to
persons
1.3. To reduce risk of battery explosion, follow these
safety instructions and those published by the
battery manufacturer and the manufacturer of
any equipment you intend to use near a battery.
Review cautionary marking on these products
and on the engine, and on the vehicle or
equipment containing the battery.
If you are uncertain as to the type of battery
you are attempting to charge, or the correct
procedure for checking the battery's state of
charge, contact the seller or battery
manufacturer.
The charger is not intended to supply power to
a low-voltage electrical system other than
applications using rechargeable, flooded type
batteries. Do not use the battery charger for
charging dry-cell batteries commonly used with
home appliances. These batteries may burst and
cause personal injury and property damage.
� � �
WARNING
Charging a non-rechargeable battery may
cause the battery to burst.
To reduce the risk of injury, only charge
rechargeable flooded type batteries including
maintenance free, low maintenance, or deep-
cycle batteries.
� � �
WARNING
Risk of explosive gases.
Batteries generate explosive gases during
normal operation and when discharged or
charged.
1.4. Never charge a frozen battery.
1.5. To reduce the risk of damage to the electric plug
and cord, pull by the plug rather than by the
cord when disconnecting the unit.
1.6. Position the AC and DC leads to avoid tripping
over them and to prevent damage by hood or
moving engine parts. Protect from heat, oil and
sharp edges.
1.7. Do not operate the unit if it has received a sharp
blow, been dropped or otherwise damaged in
any way. Take it to an approved service centre.
1.8. Do not disassemble the unit. Take it to an
approved repair centre when repair is required.
Incorrect reassembly may result in a risk of
electric shock or fire.
1.9. To reduce risk of electric shock, unplug the
charger from the AC outlet and disconnect DC
output leads before attempting any
maintenance or cleaning. Turning off the
controls will not reduce this risk.
1.10. Connect and disconnect the battery leads only
when the AC supply cord is disconnected.
1.11. Never place articles on or around the unit or
locate the unit in a way that will restrict the flow
of cooling air through the enclosure.
1.12. An extension cord should not be used unless
absolutely necessary.