GB
7.2) Operating label
This label shows how to use this device.
- Fig. 2: To lower the load, the operator must
pull the lever (No. 1) upwards. When
the operator releases the lever, load
movement stops immediately.
- Fig. 3: The movement of the truck is achieved
using the traction lever (No. 2). In this
position the jog stick (No. 1) is placed in
a central position.
- Fig. 4: To lift the load, the operator must place
the jog stick (No. 1) in the low position
and move the lever (No. 2) from top to
bottom.
- No. 3: EC marking.
- No. 4: Read these instructions before using this
device.
- No. 5: Ban use of this device for moving or lifting
persons.
7.3) Label for use of load indicator
This label illustrates the method of use for the load
indicating device.
Step 1:
- Place the handle (No. 1) in the lower
position.
- Lift the load using the lever (No. 2) until the
bubble in the spirit level attached to a tie rod
(photo 1) is positioned as shown in (Fig. 5).
- If the bubble is positioned as shown in
(Fig. 6), you need to lower the load and
repeat the operation described above.
Step 2:
- Lower the load by pulling the handle (No. 1)
up until the bubble is centred between
the lines of the spirit level (Fig. 7).
Step 3:
-
Read the load in kg shown on the
manometer on the scale in black.
Photo 1
No. 1
Fig. 2
Fig. 3
No. 2
Fig. 4
No. 5
No. 4
No. 3
No. 1
No. 2
Fig. 5
Fig. 6
Fig. 7
4
