3) Install the BSO tool pin into the hole of the
pressing roller and into the spring guide tube
{pos. 59, #36296} as shown in Figure 159.
4) Slide the spacer {pos. 70,#38555} then
spring {pos. 58,#37235} around the guide
tube (Figure 160).
5) Install the BSO tool as shown in Figure 161.
Apply pressure with your index finger and
thumb on the BSO tool.
7) Slowly and evenly, draw the tool and
pressure roller towards the spring (see
Figure 162). Keep the tool level. It will go
into the correct position without a struggle
after a little practice.
8) After the brass bushing of the pressure roller
is properly seated, turn the handle and hold.
9) Tilt the tool slightly down and remove the pin.
Remember to keep the BSO tool twisted
10) Install the driving roller, being sure it is
properly seated on the roll pin {pos. 77,
#29466}.
11) Gently release pressure on the BSO tool
until the rollers meet. Once all the pressure
is released the tool can be carefully removed.
Inspect the roller system assembly (Figure
163).
15
Figure 159
Figure 160
Figure 161
Figure 162
Figure 163
NOTE:
This procedure is much easier if the 2-piece
Blocstop tool (#20887) is used. This tool is
available from Tractel Inc.
