5) Remove the (3) center bushings {pos.
55, #38565} and (2) distance bushings
{pos. 52, #36425} as shown in Figure 122.
6) There should be (1) washer (#9826, Pos.
11) on the top of each axle, for a total of 3
(Figure 125).
7) Remove the entry {pos. 12, #36415} and
exit {pos. 13, #33685} bushings and
inspect for wear Figure 126. Excessive wear
indicates incorrect rigging practices and
should be addressed with those persons
responsible.
8
NOTE:
The centering bushings have a long side
which serves as a guide for the casing cover
{pos. 42, #18267} (See Figure 123).
NOTE:
The adjusting washers are CRITICAL to the
proper operation of the Blocstop and must be
present!
NOTE:
Prior to the removal of the adjusting washers
{pos. 11, #9826}, verify that no washers
are stuck by grease to the casing cover as
shown in Figure 124.
Figure 121
Figure 122
Figure 123
Figure 124
Figure 125
Figure 126
