NX / NXR
Use and Installation
Clamp for lifting and turning without marking the
surface of smooth or polished pieces (stainless steel,
aluminium, pre-lacquered, laminated wood, concrete
,stone, plastic, glass plates, welded-plate
assemblies, etc...).
This clamp is fitted with an automatic gripping
mechanism: the locking handle is designed to fit the
clamp over the edge of the object to be moved and
the automatic locking on the trigger grips the piece to
be lifted.
It is also fitted with a spring mechanism ensuring
permanent contact of the cam against the piece to be
lifted, even when it is laid down.
The NXR models feature adjustable jaws that are
adjustable by means of a pin in increments of
20 mm.
For Fragile pieces: Use the manual opening and
locking on the handle without bringing it to it’s
limit stop (trigger not activated).
NX instructions
1) Open the clamp by pushing the red handle (10)
down until the trigger (8) is activated. Do not
activate the trigger when handling fragile loads.
2) Fit the clamp onto the piece to be lifted, push it
home so that the throat is in contact with the edge
of the piece.
3) The trigger (8) is released, the jaws (7) come into
contact with the piece to be lifted, the red handle
(10) goes up: the safety mechanism is now
activated and the clamp is ready to lift.
4) The piece can be lifted as it is clamped by the
force of the weight.
5) Once the piece has been moved and laid down,
release the clamp by opening it via the red
handle (10).
NXR Instructions
Before performing operations 1 to 5 in the NX
instruction above complete the instructions below.
A) To adjust the opening of the clamp, remove the
pin (18).
B) Slide the mobile flanges (4) over the fixed flanges
(3) to the desired opening.
C) Put the pin (18) back a secure in place
See NX instruction 1-5 above.
CAUTION
www.tractel.com
©
T
ra
c
te
l
®
P
4
1
0
2
N
A
-
r
e
v
1
-
1
1
/2
0
1
0
22
