GB
13
Use of the Minifor
™
hoist with radio remote
control outside France is subject to verifi-
cation of compatibility of the system with the
local regulations governing the use of radio
equipment.
Radio remote-controlled Minifor
™
hoists do not
come with control pendants connected by a
control cable (Optional, on request).
11) Minifor
™
rigged
11.1. Description
The Minifor MPM
™
rigging kit can be
mounted on the Minifor
™
TR125SY model.
This arrangement doubles the capacity (WLL)
of the unit. However, the speed is halved.
The Minifor
™
should not be rigged other
than using the Minifor
™
MPM rigging kit.
No additional system should be added.
The rigging kit for Minifor
™
includes (Fig 19):
• An attachment of the suspension cable
(item 1)
• A rigging pulley with latch hook as standard
(item 3) (or self-locking hook as option)
• An assembly manual code 144445.
This kit should only be used for rigging a
Minifor
™
.
11.2. Assembly
Users should note that when rigging,
the necessary rope length is at least twice
the lift height plus 2 m with a meter of obvious
slack.
The end-of-run sliding stop on the rigging
pulley is designed to replace the top end-of-
run that comes with the rope. However, if you
want to limit the upward run, you can add a
clamp collar on the rope, placed between the
pulley and the upper end-of-run stop.
IMPORTANT:
When rigging, double
the maximum load in use to be considered
for safety calculation.
NOTE:
Take care to mount the rigging
pulley so that the sliding end-of-run is located
on the rope between the pulley and the rope
entry of the unit. See rigging kit manual.
Figure 18 shows the configuration of the
rigged Minifor
™
.
NOTE:
Given the risk of tangling the
strands of the lifting rope, we recommended
that the Minifor
™
should only be used for direct
vertical lifting (Fig. 4) when rigged.
11.3. Manoeuvre
When operating with the rigging system, the
operator will ensure specifically that the load
is cannot spin, to prevent tangling of the three
strands of the rope (two loaded s
slack). Immediately stop the movement of the
load if the slack tangles with the other strands
and untangle it before resuming movement.
For further details on the use of the rigged
Minifor
™
rigging kit.
12) Minifor
™
secured onto a vehicle ball
hitch using the MTA (fig. 20)
12.1. Description
The MTA kit secures the Minifor
™
TR125SY
onto a vehicle's a ball hitch. This arrangement
avoids installing a high winch. The MTA is
provided with a device for angular adjustment
of Minifor
™
according to the height position of
the return pulley and of the vehicle position.
The MTA kit includes (Fig. 21):
• An MTA device,
• An assembly manual code 144555.
This kit should only be used with the
Minifor
™
TR125SY.
12.2. Assembly
IMPORTANT:
Observe the assembly
instructions mentioned in the assembly
manual code 144555.
Figure 20 shows the configuration of the
rigged Minifor
™
(item 1) used with the MTA (item
2):
Item 3: return pulley (not supplied with the
MTA kit),
Item 4: clamp for activating the upper end-
of-run switch when it comes to a stop
with the upper limit end-of-run stop
Item 5,
Item 5: upper end-of-run stop of the device,
Item 6: lower end-of-travel stop,
Item 7: clamp enabling activation of the
lower end-of-travel stop.
