Traqmate User Manual V1.0
June 14, 2005
Copyright © 2005 Track Systems Technologies, LLC
Page 19
Once Traqmate has GPS signal, it will check to see if there is a Start/Finish position stored for the
current track. If not, you will see
Figure 11 - Recording a Start / Finish Location
Proceed around the track until you reach the Start/Finish line. Make sure you cross the line the
same way that you will when driving at full speed. As you reach the line press the SELECT button
to record the Start / Finish line and save it in permanent memory. At this time the Timing Screen
will appear.
If you have already recorded a Start / Finish location for the chosen track, the following screen
will appear.
Figure 12 - Searching for Start / Finish Line
This will stay onscreen until you cross the Start / Finish line when the Timing Screen will appear.
Indicates lap time of
1 hour, 20 minutes,
54.9 seconds
Up arrow when lap is
better than previous,
Down arrow when worse
Flag indicates
best lap
GPS signal
strength indicator
Lap counter
Figure 13 - Lap Timer Screen
The numbers will start over whenever the Start / Finish line is crossed and the lap counter will
increment. The lap time from the previous lap will be held onscreen for 1 minute to allow time for
viewing, and then the counting will resume.