TRACEABLE
JUMBO
ATOMIC
WALL CLOCK
INSTRUCTIONS
®
MANUALLY INITIATING SIGNAL RECEPTION
If the unit has been moved from a location where
it was receiving a strong complete signal, it is
recommended that you manually initial signal
reception to insure that the unit will receive a
complete signal in its new location.
To manually initiate signal reception:
Press and release the SET/WAVE button
will
begin flashing on the display, indicating that the
unit is attempting to receive the signal from the
Atomic Clock.
RESET BUTTON
This button is only used when the unit is operating
in an unfavorable way or malfunctioning, most
commonly caused by ESD (electrostatic discharge)
or radio interference. To reset the unit, press and
hold down the button for 2 seconds. All settings
will return to default values. Pressing the RESET
button has a similar effect as removing and re-
installing the batteries.
Control Company Cat. No. 1080
Traceable
®
is a registered trademark of
Control Company.
©
2013
Control Company.
92-1080-00 Rev. 0 070913
ALL OPERATIONAL DIFFICULTIES
If this unit does not function properly for any
reason, replace the batteries with new high quality
batteries (see “Battery Replacement” section).
Low battery power can occasionally cause any
number of “apparent” operational difficulties.
Replacing the batteries with new fresh batteries will
solve most difficulties.
BATTERY REPLACEMENT
Erratic readings, faint readings, or no display are
all indications that the batteries must be replaced.
Remove the battery cover. Remove the exhausted
batteries and replace them with a two (2) new
AA alkaline batteries. Replace the battery cover.
Upon initial installation of the battery, the unit
automatically initiates signal reception. (See the
“Operation” section for more details.)
WARRANTY, SERVICE, OR RECALIBRATION
For warranty, service, or recalibration, contact:
CONTROL COMPANY
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281 482-1714 • Fax 281 482-9448
E-mail [email protected] • www.control3.com
Control Company is ISO 9001 Quality-Certified by DNV and
ISO 17025 accredited as a Calibration Laboratory by A2LA.
