Trace2O AquaSafe WSL50, Инструкция по эксплуатации, Страница: 12 / 52

2.4 Vehicle Power
The incubator is also supplied with a vehicle cigarette lighter cable. This cable can either be
plugged into the socked on the rear of the carry case or into the incubator on the rear of the unit.
Then plug the cigarette lighter plug into the cigarette lighter socket in the vehicle. 12V or 24V
vehicle systems may be used. Note that the internal battery will not charge while connected to
the vehicle. It is advised that the vehicle’s engine should be running for the majority of the period
of time that the incubator is used to prevent discharge of the vehicle battery. Alternatively an
auxiliary battery may be used. (Cable available separately)
Note: The vehicle cigarette lighter charging lead is a specialist product and as such only a
genuine Trace2o® replacement should be used. Replacements are available from any Trace2o
®
approved representative.
No attempt should be made to charge or power the equipment other than via the approved
Trace2o
® equipment.
2.5 Fuse
The docking station contains a fuse to protect the incubator in the unlikely event of a short circuit
or thermal runaway. In the event of fuse failure the fuse may be replaced, provided the cause of
the fault is identified and rectified.
To replace the fuse, locate the fuse holder in the battery compartment as illustrated below:
Unscrew the fuse holder and remove the fuse. Replace with the same type (only as specified in
section 5.1) and screw the fuse holder back together.
Fuse
Holder