Page 11
Mode selection, continued…
Temperature Mode
25.0
Temperature data only is shown on the top line.
Select this mode to calibrate Temperature.
Press
or
to toggle between regular readout or large digit readout.
Salinity Correction Setting Mode
36.0ppK
The Salinity Correction setting is shown on the top line.
Select this mode to set the Salinity Correction value to the salinity of the
sample to be measured. This setting is only applicable to ppM (mg/L)
Dissolved Oxygen readout. See section 7.
Press
or
to toggle between regular readout or large digit readout.
Back to Dissolved Oxygen, pH/mV & Temperature mode
Note:
The decimal point is replaced by a ”
“ if a Dissolved Oxygen, pH,
mV or Temperature calibration has failed (see sections 3, 4, 5 and
6), if the unit is initialised (see section 10), or if the unit has lost its
factory calibration (see section 11.1).
