Page 23
6.3 Calibration Messages
1. If a temperature calibration has been successfully performed, the
Aqua-DP
will display the offset value of the sensor. For example…
Cal. OK
Offset=1.0
2. If a temperature calibration has failed, the
Aqua-DP
will display the
failed offset value of the sensor.
Cal. Failed
Offset=10.5
6.4 Manual Temperature Setting
1. Switch the
Aqua-DP
on.
2. Select Temperature mode (see section 2).
3. Manual temperature setting is only available if the Dissolved Oxygen
sensor is not connected.
4. Press and hold the
key for 2 seconds. The current Manual
Temperature Setting is now displayed, for example…
Enter Manual
Temp
25.0
5. Press the
and
keys until the bottom line shows the
temperature which you wish to set. This value should be the same as
the temperature of the solution you are measuring.
6. Press the
key to set the temperature.
