INSTALLATION INSTRUCTIONS
WIRE WAY ADAPTER
CAUTION: Disconnect supply service to avoid electrical shock. All wiring must conform
to nation electric code and all local codes having jurisdiction.
1. Remove junction box covers.
2. Remove bottom knockouts on bottom of junction boxes on heat shield side. Insert
snap bushings provided.
3. Using means to protect finish, place baseboard face down. Lay wires in bottom of
baseboard and feed wire through bushings into junction box allowing minimum of 6”
wire into each box.
4. Attach wire way adapter to baseboard with screws provided.
5. Mount baseboard to wall (refer to baseboard installation instructions).
6. Complete wiring connections inside junction boxes for continuous parallel wiring.
7. Reinstall junction box covers and check heater(s) for proper operation.
INSTRUCTIONS FOR PRE-INSTALLED WIRE WAY ADAPTER
1. Remove junction box covers.
2. Using means to protect finish, place baseboard face down. Remove the adapter
retaining screws and adapter.
3. Lay wires in bottom of baseboard and feed through bushings into junction box allowing
minimum of 6” wire into each box.
4. Re-install wire way adapter and secure with previously removed screws. Proceed with
Steps 5, 6 and 7 above.
WIREWAY ADAPTOR
SCREW
BASEBOARD
BACK
WRAPPER
FORM: 9932