2.FEATURES
1. Latest LED technology.
2. Low heat output.
3. Easy operating with LCD Display.
4. Three preset programs
FAST : Full power output all time.
PULSE : 0.5 second interval after full power output for
RAMP : Gradually increasing output in first half curing cycle , then Full power output till end.
• Follow the manufacturer’s instruction to adjust the curing time for better curing performance.
5. Timer: Five preset curing time from 5, 10, 20, 30, and 40 seconds.
6. Low Battery Signal
When is blinking on the LCD Display or there is a triple beep tone alarmed every 20 seconds ,
the battery needs to be charged for at least 4 hours.
7. Sleeping Mode
If the LED 70N is unused for a period of 3 minutes the curing light will convert to “Sleep Mode” to
conserve the battery.
8. Auto Memory
LED 70N will remain in previous settings. Including the curing time and the curing program.
9. Cord/Cordless Interchangeable
The LED 70N may be operated directly using AC power supply connected to the base of the handpiece.
This will allow users to operate the curing light while simultaneously charging the battery.
10. Build-in LCD Radiometer
User can monitor LED output by reading the radiometer which is located on the charging base.
F : FAST
Time (sec) 2.0
Light I
ntensity
(mW/cm
2
)
P : PULSE
Time (sec) 0.5
Light I
ntensity
(mW/cm
2
)
S : STEP
Time (sec) 0.25
Light I
ntensity
(mW/cm
2
)
2